AudioCodes Mediant 4000 SBC, User Manual

Page: 877 / 1037

CHAPTER 57 Testing SIP Signaling Calls
Mediant 4000 SBC | User's Manual
Parameter Description
■ [-1] Not Configured = The mode is according to the
'Alternative DTMF Method' and 'RFC 2833 Mode'
parameters of the IP Profile associated with the rule's
IP Group (see the 'IP Group' parameter above).
■ [0] RFC 2833 = (Default) The device sends the DTMF
digits using the RFC 2833 method (out-of-band).
■ [1] In Band = The device sends the DTMF digits in-
band (in the RTP stream).
Note:
■ The parameter is applicable only if you configure the
'Play' parameter to
DTMF .
■ Playing DTMF digits requires DSP resources when
the DTMF method is
In Band .
■ If the Test Call sends the SDP offer, the
recommended DTMF configuration of the associated
IP Profile is as follows:
✔
For RFC 2833: 'RFC 2833 Mode' = Extend ;
'Alternative DTMF Method' = As Is
✔
For In Band: 'RFC 2833 Mode' = Disallow ;
'Alternative DTMF Method' = As Is
■ If the Test Call receives the SDP offer, the
recommended configuration is as follows (i.e.,
incoming SDP offer determines the method): 'RFC
2833 Mode' =
As Is ; 'Alternative DTMF Method' = As
Is I
Authentication
Note: These parameters are applicable only if the 'Call Party' parameter (below) is configured to
Caller.
'Auto Register'
auto-register
[Test_Call_AutoRegister]
Enables automatic registration of the endpoint. The
endpoint can register to the device itself or to the
'Destination Address' or 'IP Group' parameter settings
(see above).
■ [0] Disable (default)
■ [1] Enable
'Username'
user-name
[Test_Call_UserName]
Defines the authentication username.
The valid value is a string of up to 60 characters. By
default, no value is defined.
'Password'
password
[Test_Call_Password]
Defines the authentication password.
By default, no password is defined.
Test Setting
'Call Party'
call-party
[Test_Call_CallParty]
Defines whether the test endpoint is the initiator (caller) or
receiving side (called) of the test call.
■ [0] Caller (default)
- 844 -