Atom Medical Corporation V-2200, Service Manual And Replacement Parts

Page: 15 / 212

13
Note :
⑬
and
⑭
are available only on the unit with
oxygen controller.
⑮
is available only on the unit with built-in pulse
oximeter.
⑯
,
⑰
and
⑱
are available only on the unit with
weight monitor.
Name
⑫
Relative Humidity Setting Switch
Press this switch to set a relative humidity.
When this switch is pressed, the selection of
humidity message will be displayed. and a
relative humidity can be set.
Select a desired setting by pressing an
appropriate setting switch.
⑬
ON/OFF Switch
Press this switch to turn the oxygen
controller on/off.
⑭
O
2
Switch
Press this switch to set an oxygen
concentration. When this switch is pressed,
the selection of oxygen concentration
message will be displayed, and an oxygen
concentration can be set.
Select a desired setting by pressing an
appropriate setting switch.
⑮
Alarm Limit Selector Switch
Press this switch to set an SpO
2
/pulse rate
alarm limit.
Every time this switch is pressed, selection
of a SpO
2
alarm message and the selection
of pulse rate alarm massage will be
displayed by turns, and an alarm limit for
the mode currently being displayed can be
set.
Select a desired setting by pressing an
appropriate setting switch.
⑯
Weight Switch
Press this switch to weigh or store the
measurement value.
⑰
Tare Switch
Press this switch to tare.
⑱
Mode Switch
Press this switch to change the weight
measurement mode.
⑲
Display
Displays an air temperature, a relative humidity
and an oxygen concentration in the incubator,
skin temperature, %SpO
2
, pulse rate and weight
of the infant etc. on the Numerical value screen,
Trend 1 screen and Trend 2 screen.
Name
①
Alarm Indicator
Flashes or illuminates when an alarm
condition occurs.
②
Power Failure Alarm Indicator
Illuminates when power supply is
interrupted due to power breakdown or a
disconnected power plug etc.
③
System Alarm Indicator
Illuminates when any system error is
detected by the self-diagnosis.
④
Screen Changeover Switch
Every time this switch is pressed, the
screen is changed.
⑤
Brightness Adjusting Switch
Press this switch to adjust the brightness
of the screen.
⑥
°C/°F Selector Switch
Press this switch to change the temperature
display unit from °C to °F and vice versa.
⑦
Setting Switch
Press this switch to set temperature,
relative humidity, SpO
2
/pulse rate alarm
limits, etc. to a desired level.
Every time switch is pressed, a
setting increases.
Every time switch is pressed, a
setting decreases.
⑧
Alarm Silence/ reset Switch
Press this switch to silence an audible
alarm or reset an alarm condition.
⑨
Manual Control Switch
Press this switch to operate the incubator
in the Manual Control mode.
⑩
Servo Control Switch
Press this switch to operate the incubator
in the Servo Control mode.
⑪
Override Switch
Press this switch while the Servo
indicator is flashing to select the override
mode; the
“
>37.5°C
”
indicator will flash,
and the high skin temperature range of
37.6-39.0°C will be available.
Press this switch while the Manual
indicator is flashing to select the override
mode; the
“
>37.0°C” indicator will flash,
and the high incubator air temperature
range of 37.1-39.0°C will be available.