Atom Medical Corporation V-2200, Service Manual And Replacement Parts

Page: 26 / 212

24
(Sensor-Module Section)
10
．
Set the temperature to 37.5
℃
in the servo
control mode.
11
．
Disconnect the skin temperature probe from
the sensor module.
Check:
(1) Does a skin temperature probe alarm
appear?
12. Disconnect the cable from J2 on the relay box.
Check:
(2) Does the system failure alarm indicator come on in less than 10 seconds?
(Checking the power failure alarm)
13. Disconnect the power cord.
Check:
(1) Does the power failure alarm indicator come on?
(2) Does an audible alarm sound?
(Preparation 2)
14. Set the power switch to the OFF position.
15. Attach the power cord.
(Weight Monitor)
16. Connect the weight monitor cord to the weight monitor input on the right side of the main body.
17. Turn the power switch on to activate the unit.
Check:
(1) Does “MANUAL WEIGHT MEASUREMENT
－－－－
g” appear in the message area?
18. Press the Tare switch.
Check:
(2) Does the weight monitor begin to deduct the tare, and then does it enter the continuous
measurement state?
(3) In the continuous measurement state, does the numerical value change when a little force is
applied to the mattress platform?
19. Press the Weight switch.
Check:
(4) Does the weighing procedure start, and then does a message indicating the normal completion of
measurement appear?
(End of the Test)
20. Turn the power switch off.