Atom Medical Corporation V-2200, Service Manual And Replacement Parts

Page: 156 / 212

154
Division Adjustment Serial No.
Section Setting the dip switch of the main board
Tools and jigs to be used
(1) Flat head screwdriver (small)
※
C500725, C60081X
No Adjustment procedure Remarks
1
Set the SW2 on the main board as shown above depending on the incubator
equipment.
2
Alarm setting can be changed using the SW3 on the main board. If desired,
change the setting as shown above. (SW3-1 is Available only for the board
with No. C600812 or higher).
3 Adjust the SW4 to the left side.
SW2-1
ON: the incubator is equipped with the oxygen control function
OFF: the incubator is not equipped with the oxygen control function
SW2-2
ON: the incubator is equipped with the SpO
2
function
OFF: the incubator is not equipped with the SpO
2
function
SW3-1
The alarm sound type (Available only for the board with No.
C600812 or higher) ON: 1
OFF: 2
SW3-2
The volume of Power failure alarm
ON: small
OFF: loud
SW3-3
The tone of Oxygen concentration alarm, Oxygen sensor alarm,
Oxygen flow rate alarm and Oxygen sensor position alarm ON: high
OFF: low
SW3-4
The tone of SpO
2
high/low limit alarm, Pulse rate high/low limit
alarm and SpO
2
sensor alarm
ON: high
OFF: low
SW4
Left(the white dot side): To light up the alarm lamp on the display
Right: To light up the alarm lamp on the sensor module
□
:factory default setting