AT&T System 75, Wiring Diagram

Page: 173 / 345

CHAPTER 3. EQUIPMENT ROOM DESIGN
Install connector cables between the auxiliary cabinet and cross-connect
field as follows;
1.
2.
3.
4.
5.
6.
7.
Install "D" rings on the wall between the cable slack manager and
the terminal/connecting blocks mounted on the cross-connect field.
Install a self-sticking port label on the back of each connector on
the B25A connector cable (Figure 3-43).
Note: Labels should be positioned so they will not be
obscured by the cabinet connector retainers.
At the rear of the auxiliary cabinet, connect one end of the
connector cable to the assigned connector.
Dress the cable down the back of the cabinet, and through the
cable slack manager to the cross-connect field.
At the cross-connect field, connect the other end of the cable to the
assigned terminal/connecting block connector.
Store the cable slack in the cable slack manager.
Repeat previous Steps 2 through 6 until all cables are instaIled.
Details for installing the equipment and making the connections to the
cross-connect field are included in Chapter.
Station Wiring Design
General
The following hardware and cabling is used in the station wiring design:
●
●
●
●
●
Information outlets
Station Cables
Closets
— Site locations
— Satellite locations
Adapters.
Labels
3-90