AT&T System 75, Wiring Diagram

Page: 224 / 345

Miscellaneous Wiring Installation
The maximum cabling distance for an attendant console powered from
the switch cabinet is 350 feet when using 24-gauge wire.
Installation
Install attendant console as follows:
1.
2.
Unpack console and inspect for damage.
Determine port assignment of console from Attendant Console
Form (see Note).
Carrier Slot Circuit
EXAMPLE: Port Number
A 02 01
Note: It is recommended that the primary attendant console
be connected to the control carrier. This allows for battery
holdover on System 75 and a better chance of uninterrupted
service on System 75 XE if a port carrier fails.
3.
4.
5.
7.
8.
If power is to be supplied from the switch cabinet (not available on
System 75 XE), do step 4 and omit step 5; otherwise, go to step 5.
Connect jumpers (-48V and GND)from terminal/connecting block in
yellow trunk/auxiliary Field to attendant console appearance on the
station side of the distribution field (Figure 4-16).
If power is to be supplied at cross-connect field, connect power
adapter cord to attendant console appearance on the station side
and a power unit located above the cross-connect field. If power is
not supplied at cross-connect field, provide power as described in
Adjunct Powering section in this chapter.
6. Install patch cord/jumper wires at cross-connect field.
Connect console line jack on bottom of console to information
outlet (Figure 4-15).
Install labels per Attendant Console Form and Display Module Form
Assignments.
9. Install handset bracket on left or right side of console, as desired.
4-27