AT&T System 75, Wiring Diagram

Page: 97 / 345

CHAPTER 3. EQUIPMENT ROOM DESIGN
WALL
NOTE 1
TRUNK/AUXILIARY
FIELD
CROSS-CONNECT FIELD
CABLE SLACK
MANAGER
(OPTIONAL)
NOTE 3
TABLE
PRINTER
(OPTIONAL)
SYSTEM
ACCESS
TERMINAL
(SAT)
SYSTEM
CABINET
(FRONT)
NOTE 2
32 INCHES
CHAIR
NOTES:
1.
2.
3.
THE AC POWER RECEPTACLE MUST NOT BE UNDER SWITCH CONTROL AND MUST NOT BE SHARED WITH OTHER
EQUIPMENT. THE AC POWER RECEPTACLE SHOULD BE LOCATED OUTSIDE THE CROSS-CONNECT FIELD AREA.
ALSO, ANY CONDUIT SERVING THE OUTLET CANNOT RUN THROUGH OR BELOW THE AREA WHERE THE
CONNECTOR MODULES ARE TO BE MOUNTED.
ALLOW AT LEAST 36 INCHES OF SPACE IN FRONT AND 6 INCHES ON THE RIGHTOF THE CABINET
TO PERMIT THE DOOR TO SWING OPEN.
CABINET IS LOCATED ALONGSIDE THE CROSS-CONNECT FIELD WHEN CABLE SLACK MANAGER IS NOT
USED.
Figure 3-8. Typical 2-Carrier Cabinet System 75 or 2-Cabinet
System 75 XE Floor Plan
3-14