© ANITA
MP03700EN_181101
42
Synchronizer Adjustment:
Needle up position stop adjustment
1. Turn on the power.
2. Stop the machine while the needle bar is at its
highest position.
3. The pulley reference line should be visible in the
windows
①
of the belt cover when the machine is
stopped.
Check that the distance from the top of the need le
plate to the bosom of the needle clamp is 39-
42mm at this time.
<Adjustment method>
1. Turn the machine pulley until the A mark is in
line with the red dot.
2. Turn the glisten parcel
②
until the guild light is
turned on.
3. Turn the glisten parcel
②
a little, make sure the
A mark is in line with the red dot, when the needle
is up stop position.
Needle down and thread cutter signals
1. Turn the power on.
2. Press the treadle, and then release the treadle to
neutral.
3. Make sure the gap from the top of the needle
plate to the bosom of the needle clamp is
approximately 16mm.
www.garudan.cz