© ANITA
MP03700EN_181101
33
GF-2210-147
GF-2210-447
(L)
M
H
(L)
M
H
Stitch length
2 mm
2 mm
Needle bar height (H)
2.4 mm
2.4 mm
1. Remove the needle plate.
2. Remove the feed dog.
3. Set the stitch length to eighter 2(approx. 2mm) on 3(approx. 3mm) or the scale, depending on the
model and specifications of the machine (refer to the table).
4. Turn the machine pulley to raise the needle bar by Hmm from its lowest position (refer to the
table for the value for H).
The reference line
ⓑ
oh the needle bar
⑫
will be aligned with the lower edge of the needle bar
supporter.
The rotary hook tip
⑮
must be aligned with the center of the needle at this time.
5. Till back the machine head, loosen the three screws
⑯
, and then align the rotary hook tip with
the center of the needle.
6. Tighten the screws
⑯
.
7. The distance from the upper edge of the needle hole to the rotary hook tip
⑮
must be 1-1.5mm
when the rotary hook tip is aligned with the center of the needle.
8. Loosen the set screw
⑰
to adjust so that the upper edge of the needle hole to the rotary hook, tip
is 1 - 1.5mm.
9. Turn the screw
⑲
to adjust so that the distance from the upper edge of the hole of the needle
hole to the rotary hook tip
⑮
is.
10. After adjustment is completed, insert the needle bar clamp
⑱
into the hole of the needle bar
bar
⑫
as it will
go, and check that the distance is 1 - 1.5mm.
Secure it by tightening the set screw
⑰
.
11. Install the feed dog.
12. Install the needle plate.
www.garudan.cz