© ANITA
MP03700EN_181101
12
Installing the machine head:
1.
Insert the knee lifter complying bar
①
.
2.
Insert the two hinges
②
into the holes in
the machine bed.
3.
Clamp the hinges
②
onto the rubber
Cushions
③
in the work table, and then place the
machine head onto the head cushions
④
which
are on top of the oil pan corners.
4.
Tap the pillow
⑤
into the table hole.
NOTE:
Tap the pillow securely into the table
hole. If the pillow is not pushed in as far as it will
go the machine head will not be sufficiently
stable when it is tilted back.
Remarks: The support pin must be installed reliably, otherwise there is danger when the machines is
turned over.
1.
Place the knee lifter assembly
①
onto the
knee lifter bar
②
on the oil pan, and then secure if by
tightening the bolt
③
.
2.
Adjust the knee lifter.
1) Lower the presser foot
④
by using the presser bar
lifter
⑤
.
2) Loosen rage nut
⑥
.
3) Turn the screw
⑧
to adjust so that the amount of
play in the knee lifter
⑦
is approximately 2mm when
the knee lifter plate
①
is gently pressed.
4) Securely tighten the nut
⑥
.
5) Loosen the nut
⑨
.
www.garudan.cz