© ANITA
MP03700EN_181101
19
Installing the bobbin or cap:
Installing the bobbin (GF-2207-147, GF-2207-447)
1. Turn the machine pulley to raise the needle
①
to its highest position.
2. Insert the bobbin
②
into the rotate hook
③
so that the winding direction is as shown in
the illustration.
3. Return the rotary hook latch
④
to its
original position.
4. Turn the machine pulley to rotary the rotary
hook
③
until the tension spring
⑤
is visible.
5. Pass the thread through slit A in the rotary
hook and then pass it at under through tension
spring
⑤
.
6. Pull out the thread to length of
approximately 50 mm.
7. Close the slide plates.
Installing the cap (GF-2210-147, GF-2210-447)
1. Insert the bobbin
①
into the cap
②
so that the
winding direction is as shown in the illustration.
2. Thread the thread by one of the following methods in
accordance with the shape of the cap being used.
1) Pass the thread through slot “A” and under the
tension spring
③
.
2) Pass the thread through slot “B” and “C” and
then through the thread-loosening-prevention spring.
3) Pass the thread through the thread hole
⑤
and pull out about 50mm.
3. Turn the machine pulley to raise the needle to its
highest position.
4. Insert the cap
②
into the rotary hook.
5. Push latch
⑦
of the rotary hook flat.
6. Close the bed slide.
www.garudan.cz