Amada ML-73 EL Series, Operation Manual, Page: 57 / 138

Chapter
9
53
ML-73
□□
EL
9.2 Communication Settings
Communication settings specifics are given below.
9.2 Communication Settings
Item Value (Factory-set defaults are indicated by shading.)
Electrical interface Conforms to the RS-232C specification
Method Asynchronous
Data bit length 8 bits
Stop bit length
or 2 bits
Parity check
None, odd, or
Baud rate
4800 bps, , 19200 bps, 38400 bps, 57600 bps, or 115200 bps
Flow control No
Checksum
ON or
Delimiter ETX
ON or
Of the data exchanged in RS-232C communications, the following items are stored on
the marker:
･
Serial data
･
Elapsed time for consumables
･
Transmission conditions
Other data on RAM is exchanged, not stored to the memory card. To use other data
after turning OFF the marker, you must send the data via RS-232C after restarting the
marker.
Likewise, when layout data, part data and variable data are exchanged in RS-232C
communications, only these data on RAM is changed. No problem occurs when
performing marking since marking is performed with the information on RAM, but you
need to store the contents of RAM to the memory card with the communication
command when using these data in LMDraw6. Also, when the data is changed in RS-
232C communications, the display does not change immediately depending on the
condition of LMDraw6, for example, any changes added on LMDraw6.
1
even
9600 bps
OFF
OFF
RS-232C
EQOOWPKECVKQP
RAM
/GOQT[ECTF