Chapter
6
34
ML-73
□□
EL
Chapter
6
Installation
Refer to the following figure when connecting marker components. Keep the following points in mind
when connecting the components.
•
Do not share the power supply with other large equipment.
•
Avoid bundling connecting cables or remote control cables with other power cables. The resulting
electromagnetic noise may cause malfunctions.
•
After connecting the power cable and external grounding cable to the power supply terminals, always
attach the terminal cover.
•
Connect the AC power supply.
•
The optical fiber cannot be removed from the Control Unit and the Head Unit.
•
To prevent damage, when bending the fiber, make sure the bending radius is at least 150 mm.
•
When connecting a computer to the Control Unit, you may be requested to install the software driver.
For driver installation instructions, see the manual for LMDraw6.
6.2 Connections
•
The power supply must be single-phase 100 V AC to 240 V AC, with capacity of at least 10
A.
•
The power cable provided with the equipment is exclusively for 100 V AC use. When using
a power supply other than 100 V AC, prepare an appropriate cable.
Computer
USB Cable
Optical Fiber
* Avoid bending the fiber so the bending
Head Control
Cable
Scanner Control
[Head Unit, Back]
(ML-73□0EL)
[Control Unit, Back]
Capacity: 10A or more
Single-phase 100V-240V
Power Cable
Cable
radius is less than 150 mm.
Also, do not remove the optical fiber.
[Head Unit, Back]
(ML-73□3EL)
Scanner Power Cable
(ML-73□3EL only)
Summary of Contents for ML-73 EL Series
Page 1: ...Z11OM1209102 02 Fiber Laser Marker ML 73 EL OPERATION MANUAL Original instructions...
Page 4: ......
Page 133: ...Appendix...