130
ML-73
□□
EL
Troubleshooting
If any problems occur with the equipment, error details are displayed on the liquid crystal display on the
Control Unit.
Refer to the following error details list when troubleshooting problems.
A.1 Error Messages on the Control Unit
Error Details
Cause and Corrective Action
EStop
Emergency stop circuit is open. Verify the E-Stop connector on the rear panel is closed, the
E-Stop switch on the front panel is not active.
RemIL
Remote interlock circuit is open when the laser is emitted or the laser is commanded to
emit. Close the remote interlock, remove partly processed workpieces if any, and reset the
error.
HardFlt
Displayed when an error occurred in the equipment.
For details, check the error number displayed at Error Code.
DataFlt
Displayed when the marking data error, battery error or memory card error occurs. For
details, check the error number displayed at Error Code.
Error Code
Indicates the error number of the error occurred in the equipment.
For details, refer to the error codes list on the manual for LMDraw6.
/.(CWNV5VCVWU
*CTF(NV'UVQR
&CVC(NV4GO+.
'TTQT%QFG
Appendix
A
Summary of Contents for ML-73 EL Series
Page 1: ...Z11OM1209102 02 Fiber Laser Marker ML 73 EL OPERATION MANUAL Original instructions...
Page 4: ......
Page 133: ...Appendix...