Allied Telesis AT-SB*81CFC960, Installation Manual

Page: 243 / 356

SwitchBlade x8106 Chassis Switch and AT-SBx81CFC960 Card Installation Guide
Section II: Installing the Chassis 243
 Use the SHOW CARD command to display card status
information, as shown in Figure 155 on page 236.
If the problem is with the AT-SBx81XS16 Line Card, check the following
items:
 Verify that the version of the AlliedWare Plus Operating System on
the AT-SBx81CFC960 Controller Fabric Card supports the
Ethernet line card. The AT-SBx81XS16 Line Card requires version
5.4.4 or later. To determine the version number of the operating
system on the controller card, start a management session on the
chassis and issue the SHOW SYSTEM command in the Privileged
Exec mode. For instructions, refer to “Displaying the Management
Software Version Number” on page 317. If necessary, update the
operating system on the controller card. For instructions, refer to
the Software Reference for SwitchBlade x8100 Series Switches.

Verify that the controller card in the chassis is the AT-
SBx81CFC960 Controller Fabric Card. The AT-SBx81XS16 Line
Card is not compatible with the AT-SBx81CFC400 Controller
Fabric Card.
If the problem is with the AT-SBx81XLEM Line Card or an expansion
module, check the following items:
 Verify that the version of the AlliedWare Plus Operating System on
the AT-SBx81CFC960 Controller Fabric Card supports the card or
expansion module. The AT-SBx81XLEM Line Card and expansion
modules require the versions listed in Table 31.
Table 31. AlliedWare Plus Operating System Releases for the AT-
SBx81XLEM Line Card
Model Name Initial Release
AT-SBx81XLEM Line Card 5.4.6
AT-SBx81XLEM Line Card with
large address table modes 5.4.6-1.1
AT-SBx81XLEM/Q2 Expansion
Module 5.4.6
AT-SBx81XLEM/XS8 Expansion
Module 5.4.6
AT-SBx81XLEM/XT4 Expansion
Module 5.4.6-1.1
AT-SBx81XLEM/GT8 Expansion
Module 5.4.6-2.1