62
PROG CHG: USER
DISPLAY: NUMBERS
Turn the
ROTARY DIAL
to select either "Preset", "User" or "No"
modes.
Important!
You must understand how to operate and when to use
each of these modes before you
change them!
PRESET Mode: This mode causes the organ to send a program change
number equal to the piston number that is pressed. Preset mode also
allows the organ to transmit the capture memory level value whenever the capture
memory level is changed or whenever the CANCEL piston is pressed. The General
Pistons will send program changes 1-10 on MIDI Channel 8, the organ’s General Piston
control channel. The Divisional Pistons for each division will send program changes on
the respective MIDI channels as shown on the previous page. For example, Swell Piston
1 will send Program Change 1 on MIDI Channel 1. Great Piston 2 will send Program
Change 2 on MIDI Channel 2, etc. (
See Section C-6
).
USER Mode
:
In this mode, the organ is capable of sending any program change number
on any piston that will select voices, change banks, or change program “patch” numbers
on another MIDI device. Any MIDI program change number from 1 through 127 can be
assigned to any General or Divisional Piston (blank or no digit may also be selected).
Any MIDI bank switch number between 0 and 127 can be assigned to any Divisional
Piston. As in PRESET mode, General Pistons will send program change information on
MIDI Channel 8. Divisional Pistons will send program change information on their
respective MIDI channels.
(See Section C-6)
Note:
The capture memory level value is not transmitted while in USER mode.
NO Mode: With this mode selected, NO program change information is either
transmitted or received.
3. General
MIDI
Sound
Names or Program Numbers
The GeniSys™ Controller
™
can display MIDI program changes as either MIDI program
numbers or as General MIDI sound names while in USER Program Change mode. First,
make sure the Program Change mode is set to USER
(see section C-2)
. Press the
CURSOR
button until the flashing cursor is positioned on the Display mode value.
Then, turn the
ROTARY DIAL
to change and select one of the two modes.
PROG CHG: USER
DISPLAY: NUMBERS
PROG CHG: USER
DISPLAY:GEN MIDI
