47
Release both the
SET
piston and
MEMORY
button. Step 1 is now programmed.
Repeat the above procedure to set all available crescendo step positions.
Important!
DO NOT USE THE CRESCENDO SHOE TO MOVE BETWEEN STEPS
WHILE PROGRAMMING CRESCENDO B STEP POSITIONS. Crescendo B data in
other step positions will cause the current stop registration displayed to change, i.e. a
blank step position would turn all stops off or another subsequent step position with data
(not yet re-programmed)
will change the current stop registration. When programming
the Crescendo, always use the
ROTARY DIAL
to move between steps.
To copy the current Crescendo step's stop registration to another step, use the
ROTARY
DIAL
to select a different step. Press and hold the
SET
piston, then while holding
SET
press the
MEMORY
button on the GeniSys™ Controller. The display will briefly flash
the word "DONE!!" on the first line. Release both the
SET
piston and
MEMORY
button. The previous step has now been copied to the step position indicated in the
display.
Editing A Crescendo B Sequence
Advance to the ‘CRESC/TUTTI B’ window function
(see section A-2)
. To enter the
"SHOW" mode, press the
CURSOR
button until the cursor is positioned on the mode
name within the GeniSys™ Controller. Turn
the
ROTARY DIAL
until the word
“SHOW” appears in the display. Press the
CURSOR
button until the cursor is
positioned on the word “step” in the display.
As before, the display will indicate which
step is currently activated. Use the
ROTARY DIAL
to move through the step positions
one by one while observing the stops/controls. The stops/controls will change
accordingly as to which step position is currently active.
To edit a step position you must re-enter the "SET" mode by pressing the
CURSOR
button until the cursor is positioned on the mode name “SHOW”. Turn the
ROTARY
DIAL
until the word “SET” appears in the display.
Note:
The step position indicator will remain at the current step position that was
selected in "SHOW mode.
Important:
DO NOT MOVE THE CRESCENDO SHOE AT THIS TIME.
Adjust the stop registration for that step. Once changes to the registration are complete,
save the step by pressing and holding the
SET
piston. Then, while holding
SET
press the
MEMORY
button. The display will briefly flash the word "DONE!!" on the first line.
Release both the
SET
piston and
MEMORY
button. The step is now saved to the step
position indicated in the display. To continue viewing steps you must return to "SHOW"
mode by pressing the
CURSOR
button until the cursor is re-positioned on the word
“step” within the display. Turn the
ROTARY DIAL
to view additional Crescendo steps.
Hint:
While in "SET" mode you can view the Crescendo B sequence without having to
enter the "SHOW" mode by using the Crescendo shoe. However, it is important that all
Crescendo step positions be programmed before doing this. By depressing the Crescendo
shoe, the stops/controls will move accordingly as to the step displayed. You may play
the organ while moving the crescendo shoe to hear the Crescendo sequence.
CRESC/TUTTI B
SHOW
s
tep --
