57
INSERT:SEQ01 S01
MEM 1 Gen 8
INSERT:SEQ01 S01
DONE!
INSERT:SEQ01 S01
MEM 1 Gen 8
EDIT:SEQ01 S01
MEM 1 Gen 8
Use the
CURSOR
button to position the
cursor on a data field and the
ROTARY
DIAL
to select a desired value. Blank
positions indicate the specified Sequence and
Step have no programmed contents. Enter
values for the Seq#, Step#, capture memory
level, division and piston number.
Once the desired values have been set, use the
SET
and
MEMORY
buttons to save the data to the selected step
position. "DONE!" will briefly flash on the display to indicate
the current step position has been successfully saved to
memory. Continue adding steps and sequences as desired.
In addition to creating a new piston sequence,
the INSERT mode can add step positions into
an existing piston sequence. To do this, using
the CURSOR button/ROTARY DIAL, select
an existing piston sequence number and step
position number to insert a new step.
Note:
If the step position number is positioned on the last step of the selected piston
sequence, no higher step number may be selected. The step will be appended to the end
of the piston sequence.
Select the desired values for the capture memory level, division and piston number. Use
the
SET
and
MEMORY
buttons to save the selected data. "DONE!" will briefly flash
on the display to indicate the step position has been successfully saved to memory.
Note:
Inserting and saving a new step position will move all subsequent steps within the
piston sequence up by one step position.
Important!
Do not use the INSERT mode to edit a step position. INSERT will only add
steps into a piston sequence at the selected step position.
EDITING AN EXISTING STEP POSITION
To enter the EDIT mode, press the
CURSOR
button to position the cursor on the editing
function.
Turn the
ROTARY DIAL
to select "
EDIT
"
mode.
