58
INSERT:SEQ01 S01
MEM 1 Gen 8
DELETE:SEQ01 S01
MEM 1 Gen 8
Using the CURSOR button/ROTARY DIAL, select a piston sequence number and step
position number to be changed. Then, select and edit the desired capture memory level,
division and piston number. Use the
SET
and
MEMORY
buttons to save the edited
data. "DONE!" will briefly flash on the display to indicate the edited step position has
been successfully saved to memory.
DELETING A SEQUENCE OR SINGLE STEP POSITION
To enter the DELETE mode, press the
CURSOR
button to position the cursor on
the editing function.
Turn the
ROTARY DIAL
to select
"
DELETE
" mode.
Using the CURSOR button/ROTARY DIAL, select a piston sequence number and/or step
position number that is to be deleted.
Important!
The cursor position determines whether a single step position or an entire
piston sequence is deleted.
•
If an entire piston sequence is to be deleted leave the cursor over the piston
sequence number field.
•
If a step position within a piston sequence is to be deleted leave the cursor over
the step position field.
Check the CURSOR POSITION!!
DELETE cannot by undone once it has been
performed.
Use the
SET
and
MEMORY
buttons to delete the selected
data. "DONE!" will briefly flash on the display to indicate the
selected data has been deleted successfully.
Note:
Deleting a step position within the middle of a piston sequence will cause all
subsequent steps to shift down by one step position. Empty step positions are not
allowed.
Note:
Deleting all piston sequences from memory will cause the organ to automatically
enter the INSERT mode while within the editing window.
