Alcatel 060170-10, User Manual, Page: 395 / 430

VoIP Commands
Page 5-253
Command Usage
Activate all voice numbering plans at once or by specified name.
Syntax Options
Remarks
Numbering plans do not take effect until this command is issued, or the voice daughtercard is
activated, and use of this command will not affect calls that are already in place.
Once a numbering plan is activated, all new connections are temporarily halted until this
command is completed. It can take up to approximately 10 seconds for a numbering plan to
be activated. As a result, it is recommended that this command be issued only when it will
have minimum impact on callers. It is also more efficient to activate all the numbering plans
at once, rather than individually.
Once the VoIP gateway has been configured completely using the
vsmboot.asc
file, this
command can be issued later to update or “dynamically reconfigure” the VoIP gateway. This
means certain configuration updates can be made to the VoIP gateway without rebooting the
switch as follows:
• Add VoIP gateway to VoIP network.
• Add telephone number to VoIP gateway.
• Delete telephone destination number or destination.
voice numbering plan activate
voice numbering plan { all |
“NumberingPlanName”
} activate
Definitions:
all
Activates all numbering plans at once.
NumberingPlanName Identifies the numbering plan by name, (e.g.,
salem#plan1
); maximum length of 40 charac-
ters. The following characters are permitted in the numbering plan name: a-z, A-Z, 0-9,
space and # * ~ ’ ‘ ; : , .@ $ % ^ _ & | / \ < > ( ) [ ] { }. (
Not available this release. )
♦
Syntax Notes
♦
If the
voice network card h.323 gatekeeper control
command is
ON, when the
voice numbering plan activate
command is issued,
the voice switching daughtercard automatically generates an
additional alias name. (
Not available this release. )
This command must be used directly from the CLI prompt rather
than from within the
vsmboot.asc
file. In the vsmboot.asc file,
the
voice daughter card activate
command should be used
instead.
Default:
None
Command Example:
voice numbering plan all activate
voice numbering plan salem#plan1 activate
voice numbering plan calab#plan2 activate