Alcatel 060170-10, User Manual, Page: 259 / 430

VoIP Commands
Page 5-117
Command Usage
Set Foreign Exchange Office Loop Start (FXO LS) supervisory disconnect detection signal
(enable/disable).
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo ls supervisory disconnect detection
voice signaling channel <
slot/port/startChannel-endChannel
> fxo ls supervisory disconnect
detection {on | off}
Definitions:
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
on
Turns ON fxo ls detection of supervisory disconnect for specified telephony signaling
channel.
off
Turns OFF fxo ls detection of supervisory disconnect for specified telephony signaling
channel.
♦
Syntax Note
♦
To use this command properly, the duration of the fxo ls super-
visory disconnect signal must be specified via the
voice signal-
ing fxo ls supervisory disconnect
command.
Default:
The default setting is
on
.
Command Examples:
voice signaling channel 2/1/1-12 fxo ls supervisory disconnect detection on
voice signaling channel 2/2/13-24 fxo ls supervisory disconnect detection off