Alcatel 060170-10, User Manual, Page: 218 / 430

VoIP Commands
Page 5-76
Command Usage
Specify time to wait to tear down fax call (channel timing), i.e., set the fax call holdover
delay. The delay occurs after an on-hook state is detected during fax mode operation, and
before a call clear signal is generated on the line.
Syntax Options
voice signaling fax holdover
voice signaling channel <
slot/port/startChannel-endChannel
> fax holdover <
value
>
Definitions:
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value Specifies the fax call holdover delay in milliseconds from 0 ms to 65,534, (e.g.,
2000
).
♦
Syntax Note
♦
Do not use commas when entering the fax call holdover value
(for example,
2,000
will return a syntax error message).
Default:
The default value is
2000
.
Command Examples:
voice signaling channel 2/1/1-12 fax holdover 2000
voice signaling channel 2/2/13-24 fax holdover 0
voice signaling channel 2/3/1-30 fax holdover 65534