Alcatel 060170-10, User Manual, Page: 149 / 430

VoIP Commands
Page 5-7
Specify time to wait for E&M wink on outgoing calls 5-96
Specify minimum E&M wink duration 5-97
Specify maximum E&M wink duration 5-98
Signaling Attributes (E&M Immediate Start Signaling) (Digital only)
Specify E&M immediate start time to remain off-hook when congested 5-99
Specify E&M immediate start time to wait before beginning digit collection 5-100
Signaling Attributes (E&M Delay Start Signaling) (Digital only)
Specify minimum E&M delay start response to off-hook (dial tone) state 5-101
Specify maximum E&M delay start response to off-hook (dial tone) state 5-102
Specify time to ignore incoming digits after E&M delay start 5-103
Specify E&M delay start signal detection 5-104
Specify minimum E&M delay start detection time on “M” lead 5-105
Specify maximum E&M delay start detection time on “M” lead 5-106
Specify maximum time to wait for E&M delay start detection 5-107
Signaling Attributes (Foreign Exchange Station (FXS) Loop Start Signaling)
Specify FXS loop start debounce interval to on-hook transition 5-108
Specify FXS loop start debounce interval to off-hook transition 5-109
Specify FXS loop start time to wait before declaring off-hook 5-110
Specify FXS loop start minimum time to wait before declaring on-hook by originator 5-111
Specify FXS loop start minimum time to wait before declaring on-hook by answerer 5-112
Specify FXS loop start time to wait after supervisory disconnect before declaring on-hook 5-113
Specify FXS loop start duration of supervisory disconnect 5-114
Set FXS loop start to generate outbound caller ID (on/off) 5-115
Signaling Attributes (Foreign Exchange Office (FXO) Loop Start Signaling)
Specify FXO loop start incoming ring signal debounce interval 5-116
Set FXO loop start supervisory disconnect detection (enable/disable) 5-117
Specify FXO loop start duration of supervisory disconnect detection 5-118
Specify FXO loop start time before originating calls while receiving calls 5-119
Specify FXO loop start time between ring cycles to detect ringing 5-120
Specify FXO loop start time between ring pulses to detect ringing 5-121
Set FXO loop start to detect inbound caller ID (on/off) 5-122
Specify FXO loop start number of rings allowed before answering 5-123
Specify FXO loop start debounce for loop current detector 5-124
Specify FXO loop start debounce for battery reversal detector 5-125