Alcatel 060170-10, User Manual, Page: 242 / 430

VoIP Commands
Page 5-100
Command Usage
Specify E&M immediate start time to wait before beginning digit collection.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
voice signaling emi digit wait
voice signaling channel <
slot/port/startChannel-endChannel
> emi digit wait <
value
>
Definitions:
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value Specifies time period, in milliseconds from 0 to 60,000, (e.g.,
200
), to wait for the voice
daughtercard to be ready before collecting digits. The line stays off-hook and generates a
dial tone if glare condition detected in the interim.
♦
Syntax Note
♦
Do not use commas when entering the E&M immediate start
time value, i.e., time to wait for before digit collection is enabled
and an off-hook congestion tone with glare condition is reported
(for example,
5,000
will return a syntax error message).
Default:
The default value is
200
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 emi digit wait 200
voice signaling channel 2/2/13-24 emi digit wait 30000
voice signaling channel 2/3/1-30 emi digit wait 60000