Alcatel 060170-10, User Manual, Page: 248 / 430

VoIP Commands
Page 5-106
Command Usage
Specify maximum E&M delay start detection time on “M” lead.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
voice signaling emd out detail duration max
voice signaling channel <
slot/port/startChannel-endChannel
> emd out delay duration max[imum]
<
value
>
Definitions:
slot Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
imum
Optional command syntax. Type either
max
or
maximum
in the command line.
value Specifies the maximum duration of the delay signal response on the M-lead before a glare
condition on outgoing calls can be declared, in milliseconds from 5 to 60,000, (e.g.,
100
).
♦
Syntax Note
♦
Do not
use commas when entering the value for the maximum
E&M delay signal response on the M-lead before a glare condi-
tion can be declared (for example,
1,000
will return a syntax
error message).
Default:
The default value is
8000
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 emd out delay duration maximum 8000
voice signaling channel 2/2/13-24 emd out delay duration max 3000
voice signaling channel 2/3/1-30 emd out delay duration max 60000