Alcatel 060170-10, User Manual, Page: 274 / 430

VoIP Commands
Page 5-132
Command Usage
Specify Foreign Exchange Station Ground Start (FXS GS) minimum time between open loop
and idle state.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxs gs min loop open
voice signaling channel <
slot/port/startChannel-endChannel
> fxs gs min[imum] loop open <
value
>
Definitions:
slot Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
imum
Optional command syntax. Type either
min
or
minimum
in the command line.
value Specifies the maximum time to wait after ring ground detection for loop to open after
grounding tip but before returning line to idle state, in milliseconds from 0 to 65535,
(e.g.,
100
).
♦
Syntax Note
♦
Do not use commas when entering the maximum fxs gs time to
wait value for loop to open after grounding tip (for example,
10,000
will return a syntax error message).
Default:
The default value is
100
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxs gs minimum loop open 100
voice signaling channel 2/2/13-24 fxs gs min loop open 30000
voice signaling channel 2/2/1-30 fxs gs min loop open 65535