Alcatel 060170-10, User Manual, Page: 243 / 430

VoIP Commands
Page 5-101
Command Usage
Specify minimum E&M delay start response to off-hook (dial tone) state.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
voice signaling emd in delay min
voice signaling channel <
slot/port/startChannel-endChannel
> emd in delay min[imum] <
value
>
Definitions:
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel The last number in the range of voice channels (e.g.,
30
).
♦
Syntax Note
♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
imum
Optional command syntax. Type either
min
or
minimum
in the command line.
value
Specifies the minimum duration of the delay signal response to the seize detect of incom-
ing calls on the
M-lead , in milliseconds from 0 to 60,000, (e.g.,
200
).
♦
Syntax Note
♦
Do not use commas when entering the minimum value for E&M
delay start response to off-hook (dial tone) state (for example,
5,000
will return a syntax error message).
Default:
The default value is
200
milliseconds.
Command Examples:
voice signaling channel 2/1/-15 emd in delay minimum 200
voice signaling channel 2/2/13-24 emd in delay min 30000
voice signaling channel 2/3/1-30 emd in delay min 60000