B a s i c s o f T a c t i l o n D a b a t
When there is an accessory connected to the device, you can change the
audio routing between the loudspeaker and the accessory by using the
loudspeaker on/off setting. If the accessory mode is active when you
disconnect the accessory, the audio routing returns to the state where it was
before you connected the accessory. If the loudspeaker mode is active when
you disconnect the accessory, the audio mode is not changed.
LED notification lights
The LED notification lights are used to communicate information to you. The
notification light is either blinking or remains constant. The light remains on as
long as you press the
PTT
button or as long as the operation indicated by the
notification light is active.
Green (constant)
Transmitting or automatic transmitting
Yellow (constant)
Call is queuing, connecting or changing between the
network mode (TMO) and direct mode (DMO).
Red (constant)
The call is interrupted, there is an error related to the
granting of the speech item or an error in the TETRA
application, the device is out of service or the device
is charging while it is switched on.
If the device drops out of service while the LED is
already red because of an call related error, it is
indicated by the
No service
tone.
Red (blinking)
Indicates that the device is charging while being
switched off.
A red light blinking at a low frequency indicates
receiving or idle state of an emergency call. It may
also indicate that there was an ongoing or pending
emergency call when the device dropped out of
service. If the emergency call is ended, but the device
is still out of service, the LED is a constant red.
Dabat_en_print.book Page 33 Mardi, 27. novembre 2018 5:08 17
