Air-Vac DRS27, User Manual

Page: 304 / 384

DRS27 User’s Guide Chapter 8: Maintenance
0027.00.902 8-4
8.2 Preventative Maintenance Schedule
Machine
Component Maintenance Activity Notes Frequency
Daily Weekly Monthly
Data Backup Profiles and part types must be writ-
ten to an off-machine storage media
(network server, memory stick, cd,
etc.)
Off-machine data
back-up is the most
critical maintenance
task. Air-Vac is not
responsible for lost
data. X
Nozzles Clean nozzles of flux and inspect o-
rings and vacuum cups
X
Site Clean Tool
(option)
Install the SC nozzle and activate
the SC vacuum to verify that a
strong vacuum exists. Inspect tip
collector and blue vacuum cup for
wear.
Vacuum cup should
be replaced after 8
hrs. of use
X X
Machine Frame Clean the machine frame and the
machine covers
Make sure there are no flux- or dis-
pense media spoiled on the ma-
chine
Dry lint-free cloth, in
case of flux, use flux
remover
X
Vision Unit Clean the protective cover glass on
the lower and on the upper side of
the vision unit
Kimwipes® Denatured
Alcohol
X
Pneumatic Unit Inspect and drain the air regulator
filters of any water or oil as required
(verify the air pressure is 0.55 mba)
X
Vacuum Filter Replace vacuum filter if vacuum is
insufficient to hold component.
See instructions in
Maintenance Section
X
X-Y-Z Axis Bearings Clean all the linear bearing rails
carefully.
Lubricate the bearing rails after-
wards slightly with oil
Benzine, dry lint-free
cloth
3 in 1 oil
X
Z-axis Lead Screw Clean the lead screw
Lubricate the lead screw afterwards
slightly with oil
Benzine, soft brush
3 in 1 oil X
Computer/Machine Hard Boot 8-10 hrs per shift
Nozzle Temperature Calibration See instructions in
Maintenance Section
X
Site Clean Jar Filter Change Changing filter is
dependent on usage
As required
Test Emergency Off With machine on start
any profile and press
EMO - everything
should stop and axis
should be depow-
ered.
weekly