Air-Vac DRS27, User Manual

Page: 13 / 384

DRS27 User’s Guide Chapter 1: Introduction/Overview
0027.00.902 1-7
Handling of Hazardous Solder and Flux Products
AIR-VAC does not supply the solder or flux products with the DRS27 system. The end user of the
DRS27 system should follow proper handling and disposal instructions for the materials as supplied by
their vendors.
Nozzle Changeover: Safety Equipment Requirements
When changing out the part-specific gas nozzle, use the special nozzle removal tools (GNT1, GNT4 )
that are supplied in the tool kit of the system whenever handling a hot nozzle.
Removing a nozzle:
•
Hold the hot nozzle with the nozzle removal tool and pull out of nozzle locking jaws.
•
With the hot nozzle held firmly in the removal tool, place the nozzle in a container that can handle the
heat of the nozzle.
To install a nozzle, reverse the above procedure.
1.4.3 Label Description and Placement
The following metal placards are affixed to the DRS27 system: This label describes the electrical and air
requirements for the system. The overall system requirements can be found in the facilities section of
this manual.
1.4.4 Machine warning labels
Label Indication
The Caution - Hot Surface labels found on the DRS27
system are intended to prevent injury to the operators
and users of the system. The top heater and prehea-
ter of the system are required to reach temperatures
well above 60
°
C. Labels are found on the covers of
each heated surface as well as next to heated sur-
faces.
Skin contact with these surfaces would result in a
burn reaction and therefore presents an inherent po-
tential thermal danger to the operators.
CAUTION – HOT SURFACE