Agilent Technologies 8719D, User Manual

Page: 654 / 673

external trigger,
for external monitor,
for HP-IB,
for keyboard,
test,
parallel (centronics) interface,
R channel,
serial interface,
test sequence,
test set interconnect,
connector repeatability, 5-2
connectors
rear panel,
connectors on front panel, 7-23
connectors on rear panel, 7-24
considerations for mixer measurements, 3-2
contents of disk 4-33
contents of internal memory registers, 4-33
continuous and discrete markers, 2-16
continuous correction mode for power meter
calibration, 5-39
continuous mode, test set switch, 5-57
controller
external, 1
controller interface function, 11-17
control 11-18
the test set switch, 5-57
conventions for code naming, 11-23
conversion, 6-6
conversion compression mixer measurement,
3-28
conversion loss
using tuned receiver mode, 3-17
conversion loss equation, 1
conversion loss procedure, 12
conversion loss using the frequency offset
mode, 3-7
conversion menu, 6-29
menu map, 8-5
correcting for measurement errors, 6-77
correction, 5-8
changing parameters, 5-5
state, 5-5
types, 5-4
correction procedures
use of, 5-5
Cor status notation,
couple and uncouple display markers, 2-23
coupled channels, 2-6
coupled markers, 6-9
channel power, 6-17
channel stimulus, 6-22
port power, 6-17
power, 6-17
creating a sequence, 2-66
crosstalk, 6-59
reducing, 5-59
CA status notation,
CW time sweep, 6-25
CW time-to-frequency domain, 6-136
D
data and memory viewing, 2-6
data arrays
flexibility, 4-36
data bus, 11-18
data divided by memory, 2-7
data formats, ASCII, 4-39
data loss of power calibration, 5-35
data point
definition of, 6-5
data processing, 6-4-7
data rate, 11-19
data retention for internal memory, 4-33
data statistics, 2-33
data storage
types of, 12-1
data terminal ready 11-14
data trace saved to the display memory, 2-6
data transfer, 11-18
data 11-25
(complete device clear), 11-20
debug mode, 11-25
decrease frequency span, 5-53
default file names, 4-33
default types for plotter, 4-14
default plotting parameters, 4-16
default printing parameters, 4-6
default settings, 12-7
plotter pen numbers, 4-13
defined plotting components, 4-12
define standard menus, 6-84
a plot, 4-12
the print, 4-5
definition of calibration standards, 5-28
of front panel keys,
delay block, electrical, 6-6
delay, electrical, 6-40
deleting instrument state 4-41
deleting an instrument state, 4-41
deleting a instrument state file, 4-41
deleting segments, 2-49
deleting sequence commands, 2-68
Del status notation,
delta (A) markers,
description and options, l-l
description of and softkeys,
designing 6-163