Agilent Technologies 8719D, User Manual

Page: 490 / 673

selects channel 3 memory trace for display color modification,
selects channel 3 memory trace for printer color modification.
selects channel 4 data trace for printer color modification.
selects channel 4 data trace and limit line for display color
modification.
selects channel 4 memory trace for display color modification.
selects channel 4 memory trace for display color modification.
is used to apply the same power levels to each channel.
is used to apply different power levels to each channel.
configures multiple-channel displays so that the auxiliary
channels are adjacent to or beneath the primary channels
measures A and B inputs simultaneously for faster
measurements
when the parallel port is for GPIO, 8 output bits can
be controlled with this key. When this key is pressed,
OUT BIT NUMBER” becomes the active function. This active
function must be entered through the keypad number keys,
followed by the
key. The bit is cleared when the key
is pressed. Entering numbers larger than 7 will result in bit 7
being
cleared, and entering numbers lower than 0 result in
bit 0 being cleared.
deletes all segments in the list.
clears a sequence from memory. The titles of cleared sequences
will remain in load, store, and purge menus. This is done as a
convenience for those who often reuse the same titles.
defines the standard (and the offset) as coaxial. This causes the
analyzer to assume linear phase response in any offsets
applies a linear phase compensation to the trace for use
with electrical delay. That is, the effect is the same as if a
corresponding length of perfect vacuum dielectric coaxial
transmission line was added to the reference signal path.
adjusts the degree of whiteness of the color being modified.
“Adjusting Color” for an explanation of using this for
color modification of display attributes
provides access to the configure menu. This menu contains
used to control retrace power, step sweep, raw offsets,
and the test set transfer switch.
provides access to the disk menu. This menu
contains used to the disk address, number, and
volume number.
located under the key, selects the menu.
resumes a paused sequence.
Definitions