Agilent Technologies 8719D, User Manual

Page: 649 / 673

The Keyword Reference
Keyword
CI’I’IFILE
Explanation and Examples
CITIFILE A. 01.01 identifies the as a and indicates the
revision level of the The CITIFILE keyword and revision code must
precede any other keywords. The CITIFILE keyword at the beginning
of the package assures the device reading the that the data that
follows is in the format. The revision number allows for future
extensions of the standard. The revision code shown here
following the CI’I’IFILE keyword indicates that the machine writing this
is using the version of as here. Any future
extensions of will increment the revision code.
NAME
NAME
CAL-SET the current “package” to be named. The
name of the package should be a single word with no embedded spaces.
A list of standard package names follows:
Definition
RAW-DATA
Uncorrected data.
DATA
Data that has been error corrected. When only a
single data array exists, it should be named DATA.
FORMATTED Corrected and formatted data.
MEMORY
Data trace stored for comparison purposes
CAL-SET Coefficients used for error correction.
CAL-KIT Description of the standards used
DELAY-TABLE Delay coefficients for calibration.
VAR MAG 201 the name of the independent variable
(FREQ), the format of values in a table (MAG, if
used), and the number of data points (201). Typical names for the
independent variable are FREQ (in Hz), TIME (in seconds), and POWER
(in For the VAR-LIST-BEGIN table, only the “MAG” format is
supported at this point.
#NA
1. variables to a particular type of
device to be The pound sign tells the device reading the
that the following variable is for a particular device. The “NA”
shown here indicates that the information is for a Network Analyzer.
This convention allows new devices to be without fear of
conflict with keywords for previously defined devices. The device
(i.e. NA) may be any number of characters.
SEG_LIST_BEGIN
SEG_LIST_END
SEG_LIST_BEGIN indicates that a list of segments for the independent
variable follow. Format for the segments is: [segment type] [start]
[stop] [number of points]. The current implementation only
supports a single
segment.
If there is more than one segment, the
construct is used. revision supports
only the SEG (linear segment) segment type.
SEG_LIST_END
the end of a list of independent variable
segments.
The Data Format and Reference