Agilent Technologies 8719D, User Manual

Page: 528 / 673

is used to specify the (arbitrary) impedance of the standard, in
is used to set configurations before running the service tests.
is used to direct the RF power to port 1 or port 2. (For non-S
parameter inputs only.)
is used to support specialized test sets, such as a that
measures duplexers. It allows you to set three bits
and to a value of 0 to 7, and outputs it as binary from the
rear panel connector. It tracks the coupling flag, so if
coupling is on, and FWD channel 1 is the active channel, FWD
channel 2 will be set to the same value.
is used to support specialized testsets, such as a that
measures duplexers. It allows you to set three bits
and to a value of 0 to 7, and outputs it as binary from the
rear panel connector. It tracks the coupling flag, so if
coupling is on, and REV channel 1 is the active channel, REV
channel 2
be set to the same value.
toggles the internal solid state switch from a hold mode, to a
continuously switching mode, or to a number of sweeps mode
when full
correction is enabled. Use for fast
calibration.
presents the service test menu.
selects all the non-data text for display color modification. For
example: operating parameters.
brings up the color print definition menu. The default color for
text is black.
a calibration standard type.
measures all four S-parameters in a calibration.
turns the time stamp function on or off.
adjusts the continuum of hues on the color wheel of the chosen
attribute. See
Color for an explanation of using this
for color modification of display attributes.
presents the title menu in the labels area and the
character set in the active entry area. These are used to label
the active channel display. A title more menu allows up to four
values to be included in the printed title; active entry, active
marker amplitude, limit test results, and loop counter value.
allows the operator to rename any sequence with an eight
character title. All titles entered from the front panel must
begin with a letter, and may only contain letters and numbers.
A procedure for changing the title of a sequence is provided at
the beginning of this chapter.
Key Definitions 947