87
Fig. 89 - Battery Installation
Battery Installation
Slide a
new
3 volt type CR2450 Lithium Battery, negative (-)
side down into the Battery Cavity from the right side and ensure
that it slides under the contact clip on the left rim of the cavity.
Orient the Retaining Bar across the lower portion of the Battery
and carefully push it down into position (Fig. 89).
Battery Hatch and Hatch Ring Installation
Lightly lubricate the
new
Hatch O-ring with silicone grease
and place it on the inner rim of the Battery Hatch. Ensure that it
is evenly seated. This O-ring must be a genuine AERIS part
that can be purchased from an Authorized AERIS Dealer. Use
of any other O-ring will void the warranty.
Slide the Hatch Ring, top portion first (small opening), onto
your thumb (Fig. 90).
Carefully place the clear Battery Hatch (with O-ring) into posi-
tion on the rim of the Battery Compartment, then press it evenly
and completely down into place with your same thumb.
Maintain the Battery Hatch securely in place and, using your
other hand, slide the Hatch Ring down off your thumb and into
position around the Battery Compartment. The tabs on the Ring
fit down into the slots located at the 2 and 9 o'clock positions
(Fig. 91).
(continued on page 88)
Fig. 90 -Hatch Installation
Fig. 91 -Orientation of Hatch Ring
