ABB ACS880-07XT Series, Hardware Manual, Page: 23 / 168

Introduction to the manual 23
Quick installation, commissioning and operation
flowchart
Task See
Plan the electrical installation and acquire the accessories needed
(cables, fuses, etc.).
Check the ratings, required cooling air flow, input power connection,
compatibility of the motor, motor connection, and other technical
data. Guidelines for planning the
electrical installation
(page 73 )
Technical data (page 133 )
Check the installation site. Ambient conditions (page 140 )
Unpack and check the drive (only intact units may be started up).
Make sure that all necessary optional modules and equipment are
present and correct.
Mount the drive. Mechanical installation (page 43 )
If the drive has been non-
operational for more than one year,
the DC link capacitors need to be
reformed (page
129 )
Route the cables. Routing the cables (page 85 )
Check the insulation of the supply cable, the motor and the motor
cable. Checking the insulation of the
assembly
(page 75 )
If the drive is about to be connected to an IT (ungrounded) system,
check that the drive is not equipped with EMC E200. Checking the compatibility with IT
(ungrounded) systems
(page 76 )
Connect the power cables.
Connect the control cables. Connecting the input power cables
(page 87 ), Connecting the control
cables (page 77 ),
Check the installation. Installation checklist (page 105 )
Start the drive up. Start-up (page 107 )
Operate the drive: start, stop, speed control etc. ACS880 quick start-up guide,
firmware manual