
342 Control through a fieldbus adapter
After the module configuration parameters have been set, the drive control
parameters (see section
Setting the drive control parameters
below) must be
checked and adjusted when necessary.
The new settings will take effect when the drive is powered up the next time, or when
parameter
is activated.
–
Displays the drive type code of the fieldbus
adapter module mapping file stored in the
memory of the drive.
–
Displays the fieldbus adapter module
mapping file revision stored in the memory
of the drive.
–
Displays the status of the fieldbus adapter
module communication.
–
Displays the common program revision of
the adapter module.
–
Displays the application program revision of
the adapter module.
Note:
In the
User’s Manual
of the fieldbus adapter module, the parameter group number is 1
or A for parameters
.
TRANSMITTED DATA SELECTION (see also page
…
4…6
14…16
101…9999
Defines the data transmitted from drive to
fieldbus controller.
Note:
If the selected data is 32 bits long,
two parameters are reserved for the
transmission.
…
1…3
11…13
1001…9999
Defines the data transmitted from fieldbus
controller to drive.
Note:
If the selected data is 32 bits long,
two parameters are reserved for the
transmission.
Note:
In the
User’s Manual
of the fieldbus adapter module, the parameter group number is 2
or B for parameters
and 3 or C for parameters
.
Parameter
Setting for
fieldbus control
Function/Information
Summary of Contents for ACS850 series
