3Com Router 3031, Command Reference Manual

Page: 756 / 838

756 C
HAPTER
7: M
ULTICAST
C
OMMON
C
ONFIGURATION
C
OMMANDS
View
System view
Parameter
source: IP address of multicast source (unicast address).
mask: IP address mask of multicast source.
mask-length: IP address mask length of multicast source.
protocol: Indicates that matched routes must appear in the specified unicast
routing protocol. Protocol can be such unicast routing protocols as bgp, isis, ospf,
rip and static.
route-policy: Match rule for static multicast routes.
rpf-nbr: IP address of RPF neighbor router.
interface-name Interface name which is connect to the RPF neighbor router,
including interface type and interface number.
order-num: Changes the configuration location of routes on the same network
segment. The value ranges from 1 to 100.
preference: Route preference, ranging from 1 to 255. By default, the value is 1.
Description
Using the ip rpf-route-static command, you can configure multicast static routes.
Using the undo ip rpf-route-static command, you can remove the multicast static
routes from the multicast static routing table.
For the related commands, see display multicast routing-table static config and
display multicast routing-table static.
Example
Configure a multicast static route.
<3Com> system-view
<3Com] ip rpf-route-static 1.0.0.0 255.0.0.0 rip route-policy map1
11.0.0.1
Display the multicast static route configured.
<3Com] display multicast routing-table static config
Continue to configure the multicast static route.
<3Com] ip rpf-route-static 1.0.0.0 255.0.0.0 rip route-policy map1
13.1.1.2
Display the multicast static route configured.
<3Com] display multicast routing-table static config
Continue to configure the multicast static route.
<3Com] ip rpf-route-static 1.0.0.0 255.0.0.0 null0