3Com Router 3031, Command Reference Manual

Page: 479 / 838

IPX Configuration Commands 479
not succeed in matching with the features of packet or any deny node is matched,
the packet will then be forwarded or discarded normally, up to the route table.
When multicast policy routing is configured on an interface of a router, all
multicast packets entering the router on the interface will be filtered. The filter
method is that all policy nodes of the route-policy are applied in the ascending
sequence of their ID(a number).
For the related commands, see if-match, apply output-interface, apply ip-address
next-hop, and display ip multicast-policy.
Example
Configure a route-policy named map1 with the node ID of 10 and with the match
mode of permit and enter the route-policy view.
[3Com] route-policy map1 permit node 10
[3Com-route-policy]
IPX Configuration
Commands
debugging ipx packet Syntax
debugging ipx packet [ interface-type interface-num | interface-name ]
undo debugging ipx packet [ interface-type interface-num | interface-name ]
View
User view
Parameter
■
interface-type: Interface type.
■
interface-num: Interface number.
■
interface-name: Interface name.
Description
Using the debugging ipx packet command, you can enable IPX packet debugging
switch to view the contents of IPX packet received and transmitted. Using the
undo debugging ipx packet command, you can disable the debugging switch. By
default, IPX packet debugging switch is disabled.
Example
Enable IPX packet debugging switch.
<3Com> debugging ipx packet
*0.8942310-IPX-8-IPXPKT:
Sending, interface = Serial3/0/0,
pktlen = 40, hops = 0, pkttype = 0x1,
dstnet = 0xb, dstnode = ffff-ffff-ffff, dstsocket = 0x453,
srcnet = 0xb, srcnode = 00e0-fc01-5517, srcsocket = 0x453
prompt: Sending the packet.
*0.8942610-IPX-8-IPXPKT:
Delivering, interface = Serial3/0/0,