3Com Router 3031, Command Reference Manual

Page: 559 / 838

RIP Configuration Commands 559
View
Interface view
Parameter
None
Description
Using the rip work command, you can enable the running of RIP on an interface.
Using the undo rip work command, you can disable the running of RIP on an
interface.
By default, RIP is run on an interface.
This command is used in cooperation with rip input, rip output and network
commands.
For the related commands, see network, rip input, and rip output.
Example
Disable the interface serial1/0/0 to run the RIP.
[3Com] interface serial1/0/0
[3Com-serial1/0/0] undo rip work
summary Syntax
summary
undo summary
View
RIP view
Parameter
None
Description
Using the summary command, you can enable RIP-2 automatic route
summarization. Using the undo summary command, you can disable RIP-2
automatic route summarization.
By default, RIP-2 route summarization is enabled.
Route aggregation can be performed to reduce the routing traffic on the network
as well as to reduce the size of the routing table. If RIP-2 is used, route
summarization function can be disabled with the undo summary command, when
it is necessary to broadcast the subnet route.
RIP-1 does not support subnet mask. Forwarding subnet route may cause
ambiguity. Therefore, RIP-1 uses route summarization all the time. The undo
summary command is invalid for RIP-1.
For the related command, see rip version.
Example
Set RIP version on the interface serial1/0/0 as RIP-2 and disable the route
summarization function.