ZyXEL Communications Prestige 652H series, Руководство пользователя

Страница: 561 / 583

Prestige 652H/HW Series User’s Guide
Splitters and Microfilters J-1
Appendix J
Splitters and Microfilters
This appendix tells you how to install a POTS splitter or a telephone microfilter.
Connecting a POTS Splitter
When you use the Full Rate (G.dmt) ADSL standard, you can use a POTS (Plain Old Telephone Service)
splitter to separate the telephone and ADSL signals. This allows simultaneous Internet access and telephone
service on the same line. A splitter also eliminates the destructive interference conditions caused by
telephone sets.
Install the POTS splitter at the point where the telephone line enters your residence, as shown in the
following figure.
Diagram J-1 Connecting a POTS Splitter
Step 1. Connect the side labeled “Phone” to your telephone.
Step 2.
Connect the side labeled “Modem” to your Prestige.
Step 3. Connect the side labeled “Line” to the telephone wall jack.
Telephone Microfilters
Telephone voice transmissions take place in the lower frequency range, 0 - 4KHz, while ADSL transmissions
take place in the higher bandwidth range, above 4KHz. A microfilter acts as a low-pass filter, for your
telephone, to ensure that ADSL transmissions do not interfere with your telephone voice transmissions. The
use of a telephone microfilter is optional.
Step 1. Connect a phone cable from the wall jack to the single jack end of the Y- Connector.