ZES ZIMMER LMG450, Руководство пользователя

Страница: 150 / 306

Interfaces (IEEE option L45-O1) LMG450
150
Reads the momentary flicker level of the equipment under test. After each measuring cycle
over 16 periods you can get 32 values.
10.2.4.1.5.1.9 :PST? FLST? Pstl
SCPI: :FETCh[:SCALar]:FLICker[:EUTest]:PST? /qonly/ |
:READ[:SCALar]:FLICker[:EUTest]:PST? /qonly/
SHORT: FLST? /qonly/
ID: Pstl Mode: Flicker
Type: float Suffix: 1...4
Value: n/a List: n/a
Unit: n/a Group: n/a
Reads the P
st
value of the equipment under test.
10.2.4.1.5.1.10 :RESult? FLRE? LoadOK
SCPI: :FETCh[:SCALar]:FLICker[:EUTest]:RESult? /qonly/ |
:READ[:SCALar]:FLICker[:EUTest]:RESult? /qonly/
SHORT: FLRE? /qonly/
ID: n/a Mode: Flicker
Type: long int Suffix: 1...4
Value: n/a List: n/a
Unit: n/a Group: n/a
Reads the result of the flicker measuring at the equipment under test.
Bit 0: Set if the total evaluation of the flicker fails (=if any of the sub evaluation fails). Cleared
otherwise.
Bit 1: Set if at least one P
st
value was >1.0, cleared otherwise.
Bit 2: Set if the P
lt
value was >0.65 at the END of the measuring interval, cleared otherwise.
Bit 3: Set if d
max
was bigger than limit, cleared otherwise.
Bit 4: Set if d(t) was >3% for more than allowed time, cleared otherwise.
Bit 5: Set if d
c
was > 3%, cleared otherwise.
10.2.4.1.5.2 :LTRemain? FLTR?
SCPI: :FETCh[:SCALar]:FLICker:LTRemain? /qonly/ |
:READ[:SCALar]:FLICker:LTRemain? /qonly/
SHORT: FLTR? /qonly/
ID: n/a Mode: Flicker
Type: long int Suffix: n/a
Value: n/a List: n/a
Unit: s Group: n/a
Reads the remaining long time for the flicker measurement.