ZES ZIMMER LMG450, Руководство пользователя

Страница: 231 / 306

Z E S ZIMMER Electronic Systems GmbH Chapter 11
231
11 Logging of values to drives, printer and interfaces
All menues you see can be stored to a memory card, floppy disk drives, interfaces or can be
printed out. In principal you get what you see. Some exceptions are described in the individual
chapters (e.g. you get all harmonics, not only the visible). If you want to record in single mode
you get the values you see. That means when you have frozen the display you get the frozen
values. If you are in a periodic mode then you get the actual values, also if you have frozen the
display.
The data logging is handled in a way that you have to press as few keys as possible to get the
result: To output the measured values periodically or one time to an interface or storage media.
There are no menus where you have to choose the values you want to output. Choose just one
of the available menus and press Print/Log.
You get an dialog box where you can choose the destination of the logging (with Dest.). This
can be a file, an interface or a printer.
Each single destination entry in this menu describes an output device and its most important
setting. For storage media this is the file name, for the printer the printer type and for the
interfaces the baud rate. This and other settings you can change at any time by pressing Set.
Your changes are stored in so called ‘profiles’. This profiles are stored in the memory. They
are just valid in their environment: If you change the baud rate of ComA for logging, the baud
rate of ComA for remote control is not changed!
In the dialog box you see further on the state of the chosen destination device. For storage
media you see here also the available size and the number of stored files. For printers you can
get ‘printer ready’, ‘printer busy’ or ‘paper empty’.
11.1 Start of logging
The logging itself starts, if you close the dialog box with Enter. (if you press Esc you close the
box without storing). In the status bar you get at the right side a red/green flashing log display
while the logging is active.
If you want to output to a serial interface it could happen, that this interface is already reserved
for remote control. In this case you are asked, if you want to change the usage of this interface
from remote control to logging. If you say 'Yes' the usage is changed. Please make sure, that
you don’t have any remote controlled data transfer before you press Enter.