Zeiss MMZ M, Руководство по эксплуатации

Страница: 123 / 154

Special measures
61211-1270302 MMZ M
8-5
Special measures
After a collision
If the ram or the probe collides with an obstacle, the guideway and
other components of the CMM may become damaged. In this case, per-
fect measuring operation is no longer guaranteed.
– If measurements are not possible after a collision, call a ZEISS service
engineer or our support.
Notes
NOTE
After a collision, the stylus system has to be requalified and the work-
piece position (w position) has to be determined again.
NOTE
If measurements are not possible after a collision, call a ZEISS service en-
gineer or our support.
NOTE
After a collision, the stoplight switches to red in the stoplight window.
You have to switch back the stoplight to green before continuing mea-
surement. Please refer to the operating instructions for the measuring
software.
Collision between the probe and stylus
When the probe or stylus has collided with an obstacle and the drives
have been switched off, proceed as follows:
1 Eliminate the cause of the collision.
2 Activate the collision protection.
start
active
bypass
—
Turn the key-operated switch to «start» and hold until the corre-
sponding indicator lamp lights up.
3 Reactivate the drives.
4 Check whether the stylus needs to be requalified.
NOTE
If the drives cannot be switched on, the CMM must be reinitialized.
Please refer to the operating instructions for the measuring software.