Zeiss MMZ M, Руководство по эксплуатации

Страница: 121 / 154

Malfunctions during measuring operations
61211-1270302 MMZ M
8-3
Malfunctions during measuring operations
The following table helps you identify and eliminate malfunctions that
occur during measuring operations.
NOTE
A malfunction can have different causes. One or more measures may be
necessary to eliminate a certain cause. If two measures are specified,
this does not mean that you have to take both of them to fix the prob-
lem.
Malfunction Cause Action Check
No travel
movement pos-
sible. The EMERGENCY
STOP button on the
control console or
the controller cabinet
is locked.
Unlock the EMERGENCY STOP
button:
– Turn the button slightly.
The button pops out
a few millimeters.
Collision, for example
with the workpiece. – Eliminate the cause of the colli-
sion.
– Reactivate the drives.
– Reinitialize the CMM if neces-
sary.
«AUTO» operating
mode set or
key-op-
erated switch in «0»
position.
– Turn the key-operated switch to
«MAN».
A CNC function has
been activated and is
not yet complete,
e.g. a semi-automatic
measurement run. – Wait until the measurement run
is finished.
The CMM is in the
end position. See
The pressure is too
low. – Increase the pressure in the
supply line. Pressure gauges
The filter is clogged. – Change the filter.
Travel move-
ment too slow. The set travel speed is
too low. Increase the travel speed:
– Turn the control knob on the
control console clockwise.