16
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
2.4.6
Drive Train, Axes
Each axis (X, Y and Z) rides on precision linear guideways, with four preloaded recirculating ball carriages.
Each axis is moved via a 6 mm pitch ballscrew. The axis motors drive each axis via a timing belt except on
the Z axis where it is directly driven.
2.4.7
Worktable
The 2 OP table utilizes Ball Lock® technology as well as conventional T-bolt construction. The software on
the 2 OP mill allows the user to save the X and Y location of your program relative to the lower left hand
corner ball lock. See the programming manual for more information. There are 4 ball lock receivers
mounted in the table on 300mm centres. The front 2 ball lock receivers are to be used to locate your
fixture and the rear two are for clamping purposes.
Figure 2.4.7a
2.4.8
Home switches
Each axis has a home switch which is used to home the mill. The machine must be homed each time the
control is powered on.
Warning
It is not recommended that the position of the home switches be changed. They are preset
at the factory and should require no additional adjustments. Should any major adjustments
be done, service codes 500, 505, and 520 will need to be performed.
2.4.9
Lubrication System
An automatic, centralised lubricating system is fitted to the 2OP. The pump and reservoir (capacity: 1 litre)
are located on the left side of the machine. While the system is automatic, it is recommended that, after
long idle periods, the machine be manually lubricated by using service code 300. Cycle the lube pump two
or three times. The lubrication reservoir should be maintained on a daily basis, filling only with high quality
lubricating oil. See section 3.3
2.4.10
Coolant and Coolant Wash System
The coolant system uses a single pump to provide coolant to the work and also to wash swarf away from
the area where the ATC comes out. Wash areas can be controlled by the flexible coolant lines found at the
base of the enclosure.
Содержание TRAK 2OP M11 Mill
