80
XYZ Machine Tools Ltd
TRAK
2
OP
Installation, Maintenance, Service & Part List Manual
Code
Description
Comment
Group A - Software
33
Software, Firmware and PLC
versions
Displays current software versions and system
settings.
141
Load configuration file from USB
thumb drive
To load configuration files from a USB thumb drive to
the TMX control.
142
Save configuration file to USB
thumb drive
To save the configuration files for reloading later, for
example, before changing a computer module.
316
Update Software
Runs the routine that copies new software from a USB
thumb drive device to the ProtoTRAK system. Use
this routine to install new ProtoTRAK software.
Group B - Machine Set-Up
122
Axis Calibration Using Offset
123
Calibration Mode
Use to calibrate the TMX control
128
Backlash Calibration Constant
Use to load backlash compensation for each axis.
500
X, Y Ball Lock Offsets
Used to enter the offsets for ball lock
505
Over-travel Limits
Used to setup and troubleshoot software limits.
510
Spindle Setup
Used to calibrate spindle, orient the spindle in relation
to the ATC, and troubleshoot any spindle encoder
related issues.
520
Set Tool Carrier Locations
Use to set the 8 ATC tool locations as well as the tool
change height.
530
Set Machine & Computer Module
Serial Numbers
Used to set the machines serial number, motherboard
MAC address and computer module serial number.
Group C - Diagnostic Codes
1
Program, File, Log Back up
The following service code captures all important data
from the 2 OP machine. This includes the users
program, configuration files, message log, fault log
etc. This is meant to be used to help us solve
problems that may pertain to our software. This file
can then be emailed to our service department.
54
Continuous Run Mode
Cycles through the program in current memory.
81
Program Panel Keyboard Test
Gives a tone feedback to a button push and highlights
the button.
131
Manual DRO
Turns off servos so you can check encoders
132
Electronic Handwheel Test
Test the EHW signals
319
Message Log
Logs the machine as it runs. It captures all key
presses, error messages and data as the machine
runs. It is saved automatically with service code 1.
320
Fault Log
A log that captures all faults and error messages.
326
Error Message Display
Displays error messages on screen
327
Display Memory Check
Displays memory availability of various devices
342
Test Light Indicator
Turns on and off some test lights used for
troubleshooting blocks per second problems.
Содержание TRAK 2OP M11 Mill
