XYZ Machine Tools TRAK 2OP M11 Mill, Безопасность, Установка, Обслуживание, Сервис и Список Запасных Частей

Страница: 74 / 203

70
XYZ Machine Tools Ltd
TRAK  2
OP
Installation, Maintenance, Service & Part List Manual
Figure 5.7.2a
5.8 Tool Carrier Diagnostics
The Automatic Tool Carrier (ATC) consists of 8 tool spots that correspond to tools 1 through 8 in your
programme. See drawing 27587-1 at the rear of the manual. (Tool number arrangement is also indicated
by a label located on the front door)
A successful, automatic tool change requires that many components of the 2 OP work together correctly:
• ATC position (Position of each tool spot relative to the centerline of the spindle;
• Spindle Orientation (of the spindle drive dogs relative the tool holder in the ATC);
• Z-axis (tool change height), and
• Automatic Draw Bar (being clamped or unclamped).
5.8.1 Tool Change Positions
The ATC has 8 tool (X, Y) locations that need to be set correctly using Service code 520. See section 6.13
for a procedure.
All 8 locations should be set by using a dial indicator to sweep in the taper on a tool. The X and Y
coordinate should be within 0.1mm on your indicator. In other words, there is some room for error, but
these tool locations cannot be set by eye. Once you have all tools set properly, press the “SAVE TABLE”
button to save all tool locations. Note: the best tool for setting the tool positons is a Coaxial indicator.
5.8.2 Spindle Orientation
Spindle orientation aligns the spindle drive dogs for proper engagement with the 30 taper tool holders held
in the ATC tool magazine. Spindle Orientation is set using Service code 510. Make sure to follow the
procedure precisely. See section 6.22 of this manual.
5.8.3 Tool Change Height
Tool change height is set using Service code 520. It will set the position where the Z-axis will clamp or
unclamp the tool. Like the spindle orientation, this setting is also very critical.