XYZ Machine Tools TRAK 2OP M11 Mill, Безопасность, Установка, Обслуживание, Сервис и Список Запасных Частей

Страница: 72 / 203

68
XYZ Machine Tools Ltd
TRAK  2
OP
Installation, Maintenance, Service & Part List Manual
2.
220VAC (208 to
240VAC):
This voltage is produced by the transformer. It is used for power to the axes
servo drives.
3. 115VAC (115 to
125VAC), 1 phase:
This voltage is produced by the transformer. It is used for power to the
computer module, which then powers the power supply, lube and coolant
Pumps.
4. 24VDC (22 to
26VDC):
This voltage is produced by the internal power supply of the computer module
and is used for most of the inputs and outputs. The voltage can be measured
between pin 1 of the 24VDC Port and the chassis ground on the computer
module or on pin 5 of the overlay power cable, as seen on figure 5.7.1b
5. +12VDC (11 to
13VDC):
This voltage is produced by the internal power supply of the computer module,
it is used to power some internal functions of the computer module and to
power the LCD controller board. The voltage can be measured between pin 3
of the Overlay Power Port and the chassis ground on the computer module, as
seen on figure 5.7.1b.
6. 10VDC: This voltage is produced by the computer module, it is used for control of the
spindle motor speed. This voltage varies depending on the value demanded for
spindle RPM (0 to 10 VDC = 0 to 6000 RPM).
7. -10VDC and 10VDC This voltage is used to set the axes motors’ speed. +10 volts commands the
motors to run at rapid speed in 1 direction and -10 volts command the motors
to run in the opposite direction.
8. 5VDC (4.75 to
5.25VDC)
This voltage is produced by the internal power supply of the computer module,
it is used to power the internal functions of the computer module and the
Overlay Interface board on the programming panel. The voltage can be
measured between pin 1 of the Overlay Power Port and the chassis ground on
the computer module, as seen on figure 5.7.1b. This voltage is monitored by
the 5VDC LED on the computer module.
Figure 5.7.1a