All information, illustrations and technical specifications in these operating instructions are based on the latest information available at the time of publication.
We reserve the right to make design changes at any time without prior notification.
69
7.0. Operation
7.5. Operating the precise overseeding unit
7.5.6. Automatic dosing
With automatic dispensing, the speed of the cellular rotor is calculated according to the following values:
•
Speed
•
Output rate
•
Qty. adaptation
•
Working width
•
Calibration value of the spreading material
The calibration value can be stored in a calibration test, see Chapter 7.5.5.4, "Calibration test" .
The output rate and product can be set directly, see Chapter 7.5..5, "General setting possibilities and displays" .
Starting automatic dosing:
The automatic dosing system will only start if there is a speed signal, a linkage signal is being output and there is
material in the hopper, see Chapter 7.5.5.11, "Error memory" .
1. Press the Start/Stop key.
The blower will start, the blue blower LED and the
blue LED in the Start/Stop key will flash until the
set speed has been reached, see Chapter
7.5.5.14, "Blower".
The LED in the Start/Stop key will turn orange when
the blower speed has been reached.
2. Only press the "Start/Stop" when the speed is
greater than 2 km/h and the hydraulics are lowered.
The dosing system will start.
The blue LED in the Start/Stop key will be lit.
Warning!
Risk of injury!
Make sure that no other persons or animals are in the danger zone during operation.
START/STOP
